Product Categories
Contact Us

HGG Head Office: 

Room 1005 ,Tongfang information Building, 448 Zhong kai da dao, Zhongkai district, 
Huizhou City,Guangdong Province ,China 516001

Tel: 86-752-3865186
Fax: 86-752-3865183
WhatsApp: 86-13480589850

E-mail: marketing@hopson-glass.com hopsonglass@gmail.com
Web:  www.hopsonglass.com    www.hopson-glass.com


Home > News > Content
Installation Steps Of Stainless Steel Glass Railings
Hopson Glass Group Co., Ltd | Updated: Jul 20, 2017

            1, embedded floor. Installation of embedded parts (after adding buried parts) railing embedded parts can only be used after the installation of the practice, the practice is to use expansion bolts and steel plate to make the rear connector, first in the civil base on the line, determine the position of the column fixed point, and then on the ground with impact drilling drilling, and then install expansion bolts, bolts to maintain sufficient length, after the bolt positioning, the bolts will tighten the same time the nut and screw between the welding die, to prevent the nut and plate loosening. Handrails and walls of decent connection also take the same approach.Glass Railings

           2, put the line. In addition to the construction of buried parts, may produce errors, so before the erection of the column, should be put back to the line to determine the location of the buried plate and the accuracy of the welding rod, if there is deviation, timely correction. The stainless steel column should be all located on the steel plate and can be welded around.Glass Railings

           3, welding column. Installation column, welding column, the need for a two-person cooperation, a hold the steel pipe to keep it vertical, in the welding can not be shaken, another person to apply welding, to be around to apply welding, and should conform to the welding specifications.

           4, welded surface tube, glass connectors. The handrail and the column are machined out of the groove at the top of the ground by stretching the line, and the angle of the site and the roundness of the handrail. Then put the armrest directly into the column groove, from one end to the other end of the installation of spot welding, adjacent handrail installation butt accurate, tight seam. After the adjacent steel pipe butt, welding the seam with stainless steel electrode, and then inlaid with plexiglass.Glass Railings

           5, polishing and grinding. After all welding, use the hand wheel machine to flatten the weld, until the weld is not obvious. Polished with flannel grinding wheel or felt for polishing, and the corresponding polishing paste, until the same as adjacent to the base material, do not show the weld.

           6. Install Glass. Inlaid with plexiglass, glass and other board, railing glass type, thickness should meet the design requirements, and should use a thickness of not less than 12mm of toughened glass; Glass installation should be safe, no loosening, glass installation location and installation method in line with the design requirements and the "Architectural Glass Application Procedure" (jgj113-97) of the relevant provisions.Glass Railings


Feedback
Hopson Glass Group Co., Ltd

If you are interested in our products ,please feel free to contact with us 

We will contact with you within 24H , thank you ! Our email is marketing@hopson-glass.com

Copyright © Huizhou Hopson Glass Group Co., Ltd. All rights reserved.